Hair straightening is not that that difficult if you take your time to pay attention to all the steps that are listed below.
Any slight mistake can cause a hair burn which is not healthy at all to your hair; you can avoid such issues with prompt preparation and by treating your hair with a product that can protect your hair from heat.
Contents
Below are steps one can follow to know how to straighten hair with a flat iron;
Step 01
Nikola from bestironindia.in say: Wash your hair, then after that, you can leave it for some time to dry until almost all water is gone, or you can also prefer to give it a blow dry. Blow drying can make your hair to at least straight than it was before and this just save you some more time.
image source: youtube.com
Remove all tangles by brushing your hair using the best straightening brush to avoid knots during the straightening process. Evenly distribute heat protection on your hair then blow dry to enable your hair dry completely.
Now plug the in the flat iron and let it heat up to the temperature of your desire depending on your type of hair.
Step 02
Divide your hair into sections then hold each section with a clip, the only section that should not be clipped should be the section of the lowest layer. Starting with hair that has the lowest layer, you are now supposed to separate your hair to a distance of between one and two inches.
This distance should be reasonably small to enable the flat iron to fit around it in an easy manner and straighten your hair in one round.
Step 03
Put the flat iron just above your scalp and shut the two hot sides together with the hair that is in between them, not that you should not straighten too close to your scalp because it might just burn you.
If you notice that there is an excess hair in the iron that is falling out, then you are advised to open it and reduce the amount of hair in your iron. Now move the iron down through the length of your hair, ensure that you put in the same amount of pressure through the entire process.
If you notice steam coming out from your hair, you should not worry because it is normal; the steam you see is just as a result of the hair protection cream evaporating.
image source: notjustanothersoutherngal.blogspot.com
Step 04
On this step, if you notice that your hair is not straight after a single pass, then you have to do it again for the second time, and if this continues, then you have to reduce the size of your hair locks or increase flat iron temperature.
Step 05
After finishing with the initial section, it is time to unpin and move to the next section, always remember to straighten from the lowest layers on to the surface.
After you are through with straightening your hair with a flat iron, now you can smooth your hair by maybe rubbing in just a drop of hair oil, and then spray your hair as you comb it downwards.
Final Word:
A flat iron is basically a heating tool that is used to get the hair to any desired shape, now why to wait, get the best flat irons and straighten your hair in a less effort and cost-effective manner by learning how to straighten hair with a flat iron and following all the instructions up to the latter.
