It is very useful to know how to repair a minor plumbing problem because you could save a lot of money. Everyone could be able to fix a little plumbing problem in your toilet, bathroom or kitchen. With our helpful tips, you can become a DIY plumbing expert, or you can try to be, without a help from local plumbers near Edinburgh. In the article below you can read about 6 useful tips that you can try and apply in your home with the right tools. Dripping faucets or overflowing toilets will be long gone for you with our tips and tricks.
- You can Replace Parts Inside Your Toilet or Faucet without Fear
You can replace your toilet flapper or faucet`s cartridge very quick and easy, without any damage because flappers are very cheap, and every package of them comes with instructions. For the reparation of faucets, you only need a screwdriver, and you can replace old faucet with the new one very easy. Nowadays faucets in the store come with a completely new cartridge, so if you hear dripping of water from your bathroom you know what to do.
- Remove Clogs Without Chemicals
You just need to insert a drain snake into the drain and push forward and back out slowly, and you will clean drain of the clog very successfully. Another trick is to use a wet-dry shop vacuum to suck out the clog and say goodbye to expensive, chemical cleaners.
- Check Your Showerhead Regularly
If your showerhead is dripping it means that is not connected tight and you can fix that very easily with thread tape. You will need a screwdriver to unscrew the showerhead than you wrap a tape in a clockwise direction, and that is it. If you have a clog in the showerhead, just put it a dish with a mix of warm water and vinegar for more than one hour.
- Forget Thread Sealing Compounds, Use Thread Tape
We are all familiar with the “pipe dope“ or thread sealing compound. They usually can drip, smear and cause many plumbing issues. We recommend a multi-purpose white tape, for gas, is yellow and pink is for water. The thicker tape is always easier for the handle, and of course, every type of tape you must roll counterclockwise around every thread.
- Use Heat to Loosen Tough Water Pipe Fittings
According to redeyesonline.net, when the pipe wrench is not working you must use heat to loosen tough water pipe fittings and a small propane torch will do the trick. First, you protect nearby walls with heat-resistant material and then use the propane torch for only a few minutes.
Of course, this tip is only for metal water pipes, do not do it on gas or plastic pipes.
- Make Your Water Heater More Efficient
Your water heater‘s thermostat should not be set too high. If you adjust your thermostat down to 115 degrees you will still have enough hot water for your needs.
Another often problem is sediment and you must clean your tank once every 3 months. This can be easily fixed, first you turn off the water heater than open the train into a dish and that is it.
We hope, we were helpful with our plumbing tips and tricks and that you can easily fix your minor problems with plumbings at your home. Learn more tips on the besttoiletguide.net